Linux version 2.4.5 (root@roamer) (gcc version 2.95.3 20010315 (release)) #6 Wed Sep 12 10:07:39 PDT 2001 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000e0000 - 00000000000eee00 (reserved) BIOS-e820: 00000000000eee00 - 00000000000ef000 (ACPI NVS) BIOS-e820: 00000000000ef000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 00000000077f0000 (usable) BIOS-e820: 00000000077f0000 - 0000000007800000 (ACPI data) BIOS-e820: 0000000007800000 - 0000000008000000 (reserved) BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved) Scan SMP from c0000000 for 1024 bytes. Scan SMP from c009fc00 for 1024 bytes. Scan SMP from c00f0000 for 65536 bytes. Scan SMP from c009fc00 for 4096 bytes. On node 0 totalpages: 30704 zone(0): 4096 pages. zone(1): 26608 pages. zone(2): 0 pages. mapped APIC to ffffe000 (011ff000) Kernel command line: BOOT_IMAGE=Linux ro root=303 Initializing CPU#0 Detected 801.799 MHz processor. Console: colour dummy device 80x25 Calibrating delay loop... 1599.07 BogoMIPS Memory: 117944k/122816k available (1430k kernel code, 4484k reserved, 521k data, 216k init, 0k highmem) Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes) Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes) Page-cache hash table entries: 32768 (order: 5, 131072 bytes) CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, vendor = 0 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 128K Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After vendor init, caps: 0383f9ff 00000000 00000000 00000000 CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000 CPU: Common caps: 0383f9ff 00000000 00000000 00000000 CPU: Intel Celeron (Coppermine) stepping 0a Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfe34a, last bus=5 PCI: Using configuration type 1 PCI: Probing PCI hardware Unknown bridge resource 0: assuming transparent Unknown bridge resource 2: assuming transparent PCI: Using IRQ router ALI [10b9/1533] at 00:07.0 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket IA-32 Microcode Update Driver: v1.08 apm: BIOS version 1.2 Flags 0x02 (Driver version 1.14) Starting kswapd v1.8 devfs: v0.102 (20000622) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x2 vesafb: framebuffer at 0xff000000, mapped to 0xc8000000, size 8192k vesafb: mode is 1024x768x16, linelength=2048, pages=4 vesafb: protected mode interface info at c000:774c vesafb: scrolling: redraw vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0 Console: switching to colour frame buffer device 128x48 fb0: VESA VGA frame buffer device pty: 512 Unix98 ptys configured Toshiba System Managment Mode driver v1.9 22/3/2001 Serial driver version 5.05a (2001-03-20) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A Real Time Clock Driver v1.10d block: queued sectors max/low 78232kB/26077kB, 256 slots per queue RAMDISK driver initialized: 16 RAM disks of 7777K size 1024 blocksize Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ALI15X3: IDE controller on PCI bus 00 dev 20 PCI: No IRQ known for interrupt pin A of device 00:04.0. Please try using pci=biosirq. ALI15X3: chipset revision 195 ALI15X3: not 100% native mode: will probe irqs later ALI15X3: simplex device: DMA disabled ide0: ALI15X3 Bus-Master DMA disabled (BIOS) ALI15X3: simplex device: DMA disabled ide1: ALI15X3 Bus-Master DMA disabled (BIOS) hda: TOSHIBA MK1517GAP, ATA DISK drive hdc: TOSHIBA DVD-ROM SD-C2502, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: 29498112 sectors (15103 MB), CHS=1836/255/63 hdc: ATAPI 24X DVD-ROM drive, 128kB Cache Uniform CD-ROM driver Revision: 3.12 Partition check: /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 loop: loaded (max 8 devices) SCSI subsystem driver Revision: 1.00 usb.c: registered new driver usbdevfs usb.c: registered new driver hub usb-uhci.c: $Revision: 1.259 $ time 10:10:13 Sep 12 2001 usb-uhci.c: High bandwidth mode enabled usb-uhci.c: v1.251 Georg Acher, Deti Fliegl, Thomas Sailer, Roman Weissgaerber usb-uhci.c: USB Universal Host Controller Interface driver PCI: Found IRQ 11 for device 00:02.0 usb-ohci.c: USB OHCI at membase 0xc8801000, IRQ 11 usb-ohci.c: usb-00:02.0, Acer Laboratories Inc. [ALi] M5237 USB usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected usb-ohci.c: v5.2 Roman Weissgaerber , David Brownell usb-ohci.c: USB OHCI Host Controller Driver NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 8192 bind 8192) IPv4 over IPv4 tunneling driver ip_conntrack (959 buckets, 7672 max) ip_tables: (c)2000 Netfilter core team NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. fatfs: bogus logical sector size 0 fatfs: bogus logical sector size 0 fatfs: bogus logical sector size 0 UMSDOS: msdos_read_super failed, mount aborted. reiserfs: checking transaction log (device 03:03) ... Using r5 hash to sort names ReiserFS version 3.6.25 VFS: Mounted root (reiserfs filesystem) readonly. Freeing unused kernel memory: 216k freed Adding Swap: 265064k swap-space (priority -1) 0x378: FIFO is 16 bytes 0x378: writeIntrThreshold is 15 0x378: readIntrThreshold is 15 0x378: PWord is 8 bits 0x378: Interrupts are ISA-Pulses 0x378: ECP port cfgA=0x10 cfgB=0x4b 0x378: ECP settings irq=7 dma=3 parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,COMPAT,ECP] parport0: irq 7 detected parport0: cpp_daisy: aa5500ff(38) parport0: assign_addrs: aa5500ff(38) parport0: cpp_daisy: aa5500ff(38) parport0: assign_addrs: aa5500ff(38) lp0: using parport0 (polling). Trident 4DWave/SiS 7018/ALi 5451 PCI Audio, version 0.14.9, 10:19:58 Sep 12 2001 PCI: Found IRQ 11 for device 00:06.0 trident: ALi Audio Accelerator found at IO 0xed00, IRQ 11 ac97_codec: AC97 Audio codec, id: 0x414b:0x4d02 (Asahi Kasei AK4543) CSLIP: code copyright 1989 Regents of the University of California PPP generic driver version 2.4.1 PPP Deflate Compression module registered Linux PCMCIA Card Services 3.1.22 options: [pci] [cardbus] [pm] Intel PCIC probe: Intel i82365sl B step ISA-to-PCMCIA at port 0x3e0 ofs 0x00, 2 sockets host opts [0]: none host opts [1]: none ISA irqs (default) = 3,4,5,7,9,10,12 polling interval = 1000 ms cs: IO port probe 0x0c00-0x0cff: clean. cs: IO port probe 0x0800-0x08ff: clean. cs: IO port probe 0x0100-0x04ff: excluding 0x408-0x40f 0x480-0x48f 0x4d0-0x4d7 cs: IO port probe 0x0a00-0x0aff: clean. cs: memory probe 0x0d0000-0x0dffff: clean. hermes.c: 12 Dec 2000 David Gibson orinoco.c 0.06c (David Gibson and others) dldwd: David's Less Dodgy WaveLAN/IEEE Driver eth0: Firmware ID 1F vendor 0x1 (Lucent) version 6.06 eth0: Ad-hoc demo mode supported. eth0: IEEE standard IBSS ad-hoc mode supported. eth0: WEP supported, "128"-bit key. eth0: MAC address 00:02:2D:0B:B2:DE eth0: Station name "HERMES I" eth0: ready eth0: index 0x01: Vcc 5.0, irq 3, io 0x0100-0x013f